#ifndef config_h
#define config_h

/**********************************
 * Sketch configuration
 */

#define SKETCH_NAME "Notification01"
#define SKETCH_VERSION "1.0"

/**********************************
 * MySensors node configuration
 */

#define MY_NODE_ID 1

#define MY_MSG_ACK 1
#define MY_MSG_RETRIES 3
#define MY_MSG_RETRY_DELAY 1


// Enable debug prints to serial monitor
#define MY_DEBUG
//#define MY_DEBUG_VERBOSE_RF24
//#define MY_SPECIAL_DEBUG
#define MY_SPLASH_SCREEN_DISABLED


// Enable and select radio type attached
#define MY_RADIO_NRF24

#define MY_RF24_PA_LEVEL					RF24_PA_MAX
#define MY_RF24_DATARATE					RF24_250KBPS
#define MY_RF24_CHANNEL						82
#define MY_RF24_BASE_RADIO_ID				0x00,0x30,0x08,0x19,0x82
#define MY_RF24_ENABLE_XTEA
#define MY_RF24_XTEA_KEY					{ 0xF0, 0xE1, 0xD2, 0xC3, 0xB4, 0xA5, 0x96, 0x87, 0x78, 0x69, 0x5A, 0x4B, 0x3C, 0x2D, 0x1E, 0x0F }
#define MY_MESSAGE_ENABLE_NONCE
#define MY_MESSAGE_ENABLE_HASH
#define MY_SMART_SLEEP_WAIT_DURATION_MS		60

#define MY_RF24_CE_PIN 9
#define MY_RF24_CS_PIN 10


/***********************************
 * NodeManager configuration
 */

#define DEBUG 0

// if enabled, enable the capability to power on sensors with the arduino's pins to save battery while sleeping
#define POWER_MANAGER 0
// if enabled, will load the battery manager library to allow the battery level to be reported automatically or on demand
#define BATTERY_MANAGER 0
// if enabled, allow modifying the configuration remotely by interacting with the configuration child id
#define REMOTE_CONFIGURATION 1
// if enabled, persist the remote configuration settings on EEPROM
#define PERSIST 1
// if enabled, a battery sensor will be created at BATTERY_CHILD_ID and will report vcc voltage together with the battery level percentage
#define BATTERY_SENSOR 0
// if enabled, send a SLEEPING and AWAKE service messages just before entering and just after leaving a sleep cycle and STARTED when starting/rebooting
#define SERVICE_MESSAGES 0

#define DISABLE_SLEEP_MODE



#endif