Start of example conversion. Added sleep to MySensors API.

libraries/MySensors/examples/HumiditySensor/HumiditySensor.ino

@@ -1,8 +1,6 @@
-#include <Sleep_n0m1.h>
 #include <SPI.h>
-#include <EEPROM.h>  
 #include <RF24.h>
-#include <Sensor.h>  
+#include <MySensor.h>  
 #include <DHT.h>  
 
 #define CHILD_ID_HUM 0
@@ -10,12 +8,14 @@
 #define HUMIDITY_SENSOR_DIGITAL_PIN 3
 unsigned long SLEEP_TIME = 30; // Sleep time between reads (in seconds)
 
-Sensor gw;
+MySensor gw;
 DHT dht;
-Sleep sleep;
 float lastTemp;
 float lastHum;
 boolean metric = true; 
+MyMessage msgHum(CHILD_ID_HUM, V_HUM);
+MyMessage msgTemp(CHILD_ID_TEMP, V_TEMP);
+
 
 void setup()  
 { 
@@ -26,10 +26,10 @@ void setup()
   gw.sendSketchInfo("Humidity", "1.0");
 
   // Register all sensors to gw (they will be created as child devices)
-  gw.sendSensorPresentation(CHILD_ID_HUM, S_HUM);
-  gw.sendSensorPresentation(CHILD_ID_TEMP, S_TEMP);
+  gw.present(CHILD_ID_HUM, S_HUM);
+  gw.present(CHILD_ID_TEMP, S_TEMP);
   
-  metric = gw.isMetricSystem();
+  metric = gw.getConfig().isMetric;
 }
 
 void loop()      
@@ -44,9 +44,9 @@ void loop()
     if (!metric) {
       temperature = dht.toFahrenheit(temperature);
     }
-    gw.sendVariable(CHILD_ID_TEMP, V_TEMP, temperature, 1);
-      Serial.print("T: ");
-      Serial.println(temperature);
+    gw.send(msgTemp.set(temperature, 1));
+    Serial.print("T: ");
+    Serial.println(temperature);
   }
   
   float humidity = dht.getHumidity();
@@ -54,17 +54,13 @@ void loop()
       Serial.println("Failed reading humidity from DHT");
   } else if (humidity != lastHum) {
       lastHum = humidity;
-      gw.sendVariable(CHILD_ID_HUM, V_HUM, humidity, 1);
+      gw.send(msgHum.set(humidity, 1));
       Serial.print("H: ");
       Serial.println(humidity);
   }
 
-  // Power down the radio.  Note that the radio will get powered back up
-  // on the next write() call.
-  delay(1000); //delay to allow serial to fully print before sleep
-  gw.powerDown();
-  sleep.pwrDownMode(); //set sleep mode
-  sleep.sleepDelay(SLEEP_TIME * 1000); //sleep for: sleepTime 
+  delay(300); //delay to allow serial to fully print before sleep
+  gw.sleep(SLEEP_TIME * 1000); //sleep a bit
 }