Start of example conversion. Added sleep to MySensors API.

libraries/MySensors/examples/LightSensor/LightSensor.ino

@@ -1,17 +1,15 @@
-#include <Sleep_n0m1.h>
 #include <SPI.h>
 #include <RF24.h>
-#include <EEPROM.h>  
-#include <Sensor.h>  
+#include <MySensor.h>  
 
 #define CHILD_ID_LIGHT 0
 #define LIGHT_SENSOR_ANALOG_PIN 0
 
 unsigned long SLEEP_TIME = 30; // Sleep time between reads (in seconds)
 
-Sensor gw;
+MySensor gw;
+MyMessage msg(CHILD_ID_LIGHT, V_LIGHT_LEVEL);
 int lastLightLevel;
-Sleep sleep;
 
 void setup()  
 { 
@@ -21,7 +19,7 @@ void setup()
   gw.sendSketchInfo("Light Sensor", "1.0");
 
   // Register all sensors to gateway (they will be created as child devices)
-  gw.sendSensorPresentation(CHILD_ID_LIGHT, S_LIGHT_LEVEL);
+  gw.present(CHILD_ID_LIGHT, S_LIGHT_LEVEL);
 }
 
 void loop()      
@@ -29,16 +27,12 @@ void loop()
   int lightLevel = (1023-analogRead(LIGHT_SENSOR_ANALOG_PIN))/10.23; 
   Serial.println(lightLevel);
   if (lightLevel != lastLightLevel) {
-      gw.sendVariable(CHILD_ID_LIGHT, V_LIGHT_LEVEL, lightLevel);
+      gw.send(msg.set(lightLevel));
       lastLightLevel = lightLevel;
   }
   
-  // Power down the radio.  Note that the radio will get powered back up
-  // on the next write() call.
-  delay(1000); //delay to allow serial to fully print before sleep
-  gw.powerDown();
-  sleep.pwrDownMode(); //set sleep mode
-  sleep.sleepDelay(SLEEP_TIME * 1000); //sleep for: sleepTime 
+  delay(300); //delay to allow serial to fully print before sleep
+  gw.sleep(SLEEP_TIME * 1000);
 }