Start of example conversion. Added sleep to MySensors API.

libraries/MySensors/examples/MotionSensor/MotionSensor.ino

@@ -1,5 +1,4 @@
 #include <MySensor.h>  
-#include <Sleep_n0m1.h>
 #include <SPI.h>
 #include <RF24.h>
 
@@ -8,15 +7,11 @@
 #define CHILD_ID 1   // Id of the sensor child
 
 MySensor gw;
-Sleep sleep;
 // Initialize motion message
 MyMessage msg(CHILD_ID, V_TRIPPED);
 
 void setup()  
 {  
-  //eeprom_write_byte((uint8_t*)EEPROM_PARENT_NODE_ID_ADDRESS, 1);
-  //eeprom_write_byte((uint8_t*)EEPROM_NODE_ID_ADDRESS, 255);
-  //delay(2000);
   gw.begin();
 
   // Send the sketch version information to the gateway and Controller
@@ -24,9 +19,7 @@ void setup()
 
   pinMode(DIGITAL_INPUT_SENSOR, INPUT);      // sets the motion sensor digital pin as input
   // Register all sensors to gw (they will be created as child devices)
-  delay(500);
   gw.present(CHILD_ID, S_MOTION);
-  delay(1000);
   
 }
 
@@ -38,12 +31,8 @@ void loop()
   Serial.println(tripped);
   gw.send(msg.set(tripped?"1":"0"));  // Send tripped value to gw 
  
-  // Power down the radio.  Note that the radio will get powered back up
-  // on the next write() call.
-  delay(200); //delay to allow serial to fully print before sleep
-  gw.powerDown();
-  sleep.pwrDownMode(); //set sleep mode
-  sleep.sleepInterrupt(INTERRUPT,CHANGE);
+  // Sleep until interrupt comes in on motion sensor. Send update every two minute. 
+  gw.sleep(INTERRUPT,CHANGE, 120000);
 }