Henrik Ekblad
dfcd3d44d3
Remove unused libraries. Add default CS/CE pin to Config.h Add new variebles for voltage and current. Add new internal command sent to controller when gateway is ready and online
24 lines
903 B
C
24 lines
903 B
C
#ifndef MyConfig_h
|
|
#define MyConfig_h
|
|
|
|
/***
|
|
* Configure Sensor Network
|
|
*/
|
|
#define RF24_CHANNEL 76 //RF channel for the sensor net, 0-127
|
|
#define RF24_DATARATE RF24_250KBPS //RF24_250KBPS for 250kbs, RF24_1MBPS for 1Mbps, or RF24_2MBPS for 2Mbps
|
|
#define RF24_PA_LEVEL RF24_PA_MAX //Sensor PA Level == RF24_PA_MIN=-18dBm, RF24_PA_LOW=-12dBm, RF24_PA_HIGH=-6dBM, and RF24_PA_MAX=0dBm
|
|
#define RF24_PA_LEVEL_GW RF24_PA_LEVEL //Gateway PA Level, defaults to Sensor net PA Level. Tune here if using an amplified nRF2401+ in your gateway.
|
|
#define BASE_RADIO_ID ((uint64_t)0xA8A8E1FC00LL) // This is also act as base value for sensor nodeId addresses. Change this (or channel) if you have more than one sensor network.
|
|
|
|
// MySensors online examples defaults
|
|
#define DEFAULT_CE_PIN 9
|
|
#define DEFAULT_CS_PIN 10
|
|
|
|
|
|
/***
|
|
* Enable/Disable debug logging
|
|
*/
|
|
#define DEBUG
|
|
|
|
#endif
|