Olivier
8bb3cfb2e1
* Bump version to 2.2.0-beta (#713) * OTA: Add incoming FW block check (#718) * Linux: Add support for SPIDEV (#734) RPi and Linux refactor. Add GPIO Sysfs for GPIO operations. Update configure script. Fix some cppcheck warnings. Add serial emulation that prints to stdout. Fix some file headers. * Fix getControllerConfig() (#737) * Rename MyHwATmega328 to MyHwAVR (#738) * AVR: Restrict fast pin function use (#739) * Fix signing presentation bug (#740) * Consolidate open PRs for bugfix release (#741) * Revert "Bump version to 2.2.0-beta" (#744) * Merge Master into Dev (#745) * Fix spi flash error when compiling in Arduino IDE 1.6.6 * Bump minor version * Fixed "invalid suffix on literal" warning * Fix addressing bug in _doSign bitfield * Make sure nodes not supporting signing informs GW A node that does not support signing, still needs to inform the gateway about this to make sure the gateway carries a valid signing requirement table when a node Id that was requiering signing stops doing this. This fixes #286. * Prevent SecureActuator from accepting ACKs as commands As ACKs are not currently signed, allowing ACKs as commands is a considerable security hole for this sketch. This is now resolved. * Backport of bugfix (#259) in repeaters when forwarding signed messages * Bumped version to 1.5.2 * Corrected doSign variable name (was _doSign) * Bumped version to 1.5.3 * Add NULL termination to payloads Messages addressed to "this" node, will have a null char appended to the payload after message verification is done, because some "getters" assume the message being a string. * MySensors 2.1.1 release
MockMySensors
Arduino sketch to fake sensor for the MySensors Library
This skecth is intended to crate fake sensors which register and respond to the controller
Barduino, GizMoCuz 2015
Comment/Uncomment the sensors you would like to test
Arduino Uno R3 can support about 12 sensors before it runs out of memory. (turning off the MySensors debug helps if you are memory limited)
With a Mega you can have them all
Changes Log
2015-09-07 Five more sensors S_RGB_LIGHT S_RGBW_LIGHT S_COLOR_SENSOR S_HVAC S_MULTIMETER Consolidated HVAC and HEATER incoming message
2015-09-06
Merge with Gizmocuz (implementation of S_HEATER & S_MOISTURE Implementation of S_COVER, S_IR, S_SCENE_CONTROLLER
2015-08-19
Removed the load/save to eeprom Touched the heater sensor Created a pseudo sensor to handle the V_ARMED message. All sensors which support V_ARMED will arm/disarm at the same time