* Bump version to 2.2.0-beta (#713)
* OTA: Add incoming FW block check (#718)
* Linux: Add support for SPIDEV (#734)
RPi and Linux refactor.
Add GPIO Sysfs for GPIO operations.
Update configure script.
Fix some cppcheck warnings.
Add serial emulation that prints to stdout.
Fix some file headers.
* Fix getControllerConfig() (#737)
* Rename MyHwATmega328 to MyHwAVR (#738)
* AVR: Restrict fast pin function use (#739)
* Fix signing presentation bug (#740)
* Consolidate open PRs for bugfix release (#741)
* Revert "Bump version to 2.2.0-beta" (#744)
* Merge Master into Dev (#745)
* Fix spi flash error when compiling in Arduino IDE 1.6.6
* Bump minor version
* Fixed "invalid suffix on literal" warning
* Fix addressing bug in _doSign bitfield
* Make sure nodes not supporting signing informs GW
A node that does not support signing, still needs to inform the
gateway about this to make sure the gateway carries a valid signing
requirement table when a node Id that was requiering signing stops
doing this.
This fixes#286.
* Prevent SecureActuator from accepting ACKs as commands
As ACKs are not currently signed, allowing ACKs as commands
is a considerable security hole for this sketch. This is now resolved.
* Backport of bugfix (#259) in repeaters when forwarding signed messages
* Bumped version to 1.5.2
* Corrected doSign variable name (was _doSign)
* Bumped version to 1.5.3
* Add NULL termination to payloads
Messages addressed to "this" node, will have a null char
appended to the payload after message verification is
done, because some "getters" assume the message being a
string.
* MySensors 2.1.1 release
* Add critical section support
Allows defining a code block which is executed as a critical section.
Supports AVR, ESP8266 & SAMD.
* Add receive message buffering
When MY_RF24_IRQ_PIN is defined (and connected), a buffer will be used
to retrieve & store messages received by nRF24 as fast as possible.
This reduces the chance of losing messages due to a busy
microcontroller.
nRF24 SPI rx message transfer is running from interrupt context when
MY_RF24_IRQ_PIN is defined. If this transfer takes too long, serial
characters received will get lost. Therefore serial rx is enabled during
SPI transfer of nRF messages.
Limitations: Only AVR/SAMD & nRF24L01+ combinations can buffer rx
messages.
nRF24L01+ IRQ pin should be connected to AVR.
Tested on W5100- & Serial-gateway.
SAMD has not been tested yet!
* Fix Doxygen warnings
* Fix more Doxygen warnings
Olivier
Patrick Fallberg
Thomas Mørch
Marcelo Aquino
tekka007
Embedded Innovation
Thomas Mørch