If MY_GATEWAY_CLIENT_MODE or MY_CONTROLLER_URL_ADDRESS are present, set
MY_GATEWAY_CLIENT_MODE.
MY_USE_UDP requires that MY_GATEWAY_CLIENT_MODE is set.
Add some ifdefs to filter some variables not needed in client mode.
Using global variables to keep the connection to controller open
therefore, no need to reconnect every time we need to send/receive
something.
Add the remaining code to handle incoming messages from controllers.
Removing MY_LED_BLINKING_FEATURE, as we now are
using MY_DEFAULT_LED_xx_PIN defines to enable
LED blinking feature.
updated Gateway sketches to not refer to
MY_LED_BLINKING_FEATURE any more
fixes#562
* Add critical section support
Allows defining a code block which is executed as a critical section.
Supports AVR, ESP8266 & SAMD.
* Add receive message buffering
When MY_RF24_IRQ_PIN is defined (and connected), a buffer will be used
to retrieve & store messages received by nRF24 as fast as possible.
This reduces the chance of losing messages due to a busy
microcontroller.
nRF24 SPI rx message transfer is running from interrupt context when
MY_RF24_IRQ_PIN is defined. If this transfer takes too long, serial
characters received will get lost. Therefore serial rx is enabled during
SPI transfer of nRF messages.
Limitations: Only AVR/SAMD & nRF24L01+ combinations can buffer rx
messages.
nRF24L01+ IRQ pin should be connected to AVR.
Tested on W5100- & Serial-gateway.
SAMD has not been tested yet!
* Fix Doxygen warnings
* Fix more Doxygen warnings
Olivier
Patrick Fallberg
tekka007
Henrik Ekblad
Olivier
Marcelo Aquino
Thomas Mørch
Thomas Mørch
Embedded Innovation