Adjusted all Gateway examples but only one sensor example so far
(DallasTemperature). Other sensor examples should get the same three
lines added (not mandatory but helps avoiding unnecessary debugging when
selecting the wrong setup)
Retry parent node search with each transmit when parent has not been
found.
Transmit does not block on transmit when no parent has been found as
this depletes batteries on battery powered nodes.
Fix nRF24 configuration for dynamic ACK's. This bug caused broadcasts to
be sent with auto-ACK's.
To not break existing functionality parent search can be started when
node ID is still unknown. In this case node ID is set to broadcast ID,
which can cause funky stuff to happen...
This is a preparation for handling multiple interrupts in delay().
It also reduces the size of the interrupt-related variables and
arguments to int8_t as that should be ample enough for any Arduino
implementation.
The difference between the interrupt driven binary switch example and
the normal binary switch example is the following:
* Interrupt example does not use debouncer because it rely on loop()
iterating over time (but it sleeps between iterations)
* Interrupt example is more power conservative because it sleeps as soon
as it has sent updated data and no activity happens on the pin
* Interrupt example is limited to only two IO pins for the sensor, due
to limitations in the Arduino HW. The example uses the preprocessor to
ensure that this is not misconfigured or sleep function can not be
expected to behave as intended.
Move all gateway examples to "examples" to work better with codebender and Arduino IDE.
Ledmode is always enabled for gateway. Still optional to connect the wires though ;)
Move MsTimer to local utility folder (no external dependencies).
Remove unused libraries.
Add default CS/CE pin to Config.h
Add new variebles for voltage and current.
Add new internal command sent to controller when gateway is ready and online
radioId;childId;messageType;ack;subType;payload\n
Where ack parameter means the following:
outgoing: 0 = unacknoledged message, 1 = request ack from destination node
Incoming: 0= normal message, 1=This is an ack message
ToSa27
Henrik Ekblad
Yveaux
Patrick Fallberg
Daniel Wiegert